INSTALLATION AND USER INSTRUCTIONSAll instructions must be handed to user for safekeepingRevision A - 08/05Country(s) of destination - GB/IEAFINACONVE
GAS CONNECTIONRefit the burner tray into the firebox, fit the twoscrews through the locating holes in the tray legs,and tighten.Purge the gas supply t
FUEL BED LAYOUT ((continued)3. Open the bag of 16 moulded coals. All of the coalsare the same. Take five coals and place them asshown. Care should be
FUEL BED LAYOUT Pebble EEffect OOption1. Refer back to section 12.0 - Fuel bed layout (coaleffect option) and follow steps 1 and 2. The front stripand
FUEL BED LAYOUT - ccontinued5. Finally, take the four remaining pebbles and placeat the back of the fuel matrix as shown. Once again, the pebbles may
OPERATING TTHE FFIRE ((continued)To decrease the setting to LOW, turn the control knob clockwise to the low setting.To turn to the PILOT position from
TESTING FOR SPILLAGEClose all doors and windows to the room containing the appliance. Let the fire run on HIGH for five minutes.Take a smoke match, li
SERVICING ((continued)7. Check the area behind the firebox for rubble accumulation and remove. If debris is excessive, initiateremedial work on the fl
TROUBLESHOOTING GGUIDEFire ssparkss bbut ppilot ddoess nnot lligghtNo gas to fire, check isolators are open.Pipework blockage, clean out.Air not fully
USER INSTTRUCTTIONSIMPORTANT NNOTESThe installation of this fire MUST only be carried out by a competent person (such as a CORGI registered fitter)in
FIREFRONTThis fire is supplied with a particular style of firefront. Use of the firefront will ensure an adequate airflow underthe firebed for the cor
INSTTALLATTION IINSTTRUCTTIONSPPrelimminnary NNotes BBefore IInnstallationnThis appliance is an Inset Live Fuel Effect appliance which provides radian
FLUE SSPILLAGE MMONITORING SSYSTEMThis fire is fitted with a flue spillage safety device (ODS). If the fire shuts down during use for no apparent reas
IMPORTANT NNOTESThis fire is an Inset Live Fuel Effect Gas Fire providing radiant warmth. It is designed to operate on Natural Gasonly. See Data Plate
INSTALLATION RREQUIREMENTSThis appliance MUST NOT be installed into a room containing a bath or shower, or where steam may bepresent. The fire has bee
SITE RREQUIREMENTS ((continued)This appliance required a natural draught flue system which may be one of the following;225mm x 225mm (9in x 9in) brick
DEBRIS CCOLLECTION SSPACEThe mounting depth of this appliance is 250mm. In accordance with BS 5871, minimum debris collection vol-umes are required be
PREFABRICATED FFLUE BBOXES ((continued)Some flue boxes may require minor adaption when fitting the fire using the cable fixing kit.The firebox, base o
PREPARING TTHE AAPPLIANCE ((continued)Knockout holes are provided in the rear and sides of thefirebox for use where concealed pipework is required.Whe
GAS SSUPPLY RROUTING ((continued)The gas pipe must be suitably protected where it passes through fireplace openings. Any sleeving should besealed to t
Komentáře k této Příručce